Question: Mike, I am an apprentice electrician and I was told that the 1999 NEC requires wall-mounted
receptacles for commercial buildings to be mounted so that the bottom of the cover plate is no less
than 15 inches from the floor. Is this True?
Mike Answer: No. There is no NEC requirement on the height of wall-mounted receptacles in residential,
commercial, or industrial facilities, butů.
American Disabilities Act Requirement
The Code of Federal Regulations 28 Part 36 (American Disabilities
Act) in Section 4.27.3 states that electrical and communications system receptacles on walls shall
be mounted no less than 15" above floor. However, the exception indicates that this does not
apply to receptacles not intended for use by building occupants. The maximum height for receptacles
and/or switches is between 48 and 54 inches, depending on the conditions, see Section 4.2.5 and 4.2.6
of the ADA.
From: Tracey Leach-Casey firstname.lastname@example.org
The N.E.C may not have requirements for receptacle heights, but if
the jurisdiction you are working in enforces CABO/ANSI A117.1 1992 for Accessibility, Section
4.25.3 (exception) states: Electrical and communication system receptacles on walls shall be mounted
15 inches above the floor unless the use of special equipment requires location at a different position.
The ANSI standard is referenced in the 1997 U.B.C section 1101.3.
From: Gilbert Gonzales
Regarding the question on the 15" receptacle height: The Uniform
Building Code 1106.3.3 on Accessibility for the handicapped uses 15" to 48" for operating
control heights within Section 1106 dealing with lighting controls, electrical receptacles, environmental
controls, security and intercom
systems. You would have to read UBC 1103 to see if your occupancy type applies, but it generally covers