Visit MikeHolt.com
New UL GFCI Standard  

 

Underwriters Laboratories (UL) has announced a revision to standard UL 943 that became effective on June 29, 2015. Because testing a GFCI is a good way to verify that it is providing protection, the revision requires that all UL certified Class A residential and commercial grade wallbox mounted GFCIs have: Image

 

a) An auto-monitoring function that will allow for periodic automatic testing (self-test) of the GFCI device and its ability to respond to a ground fault. If a problem is detected one or more of the following will happen:

- Power will be denied (trip with the inability to reset)

- Trip with the ability to reset, subject to the next auto-monitoring test cycle or repeatedly trip

- Visual and/or audible indication

b) Provisions to ensure that receptacle type GFCIs that contain separate line and load terminals, and that is powered through its load terminals, shall not reset and supply power to its receptacle face or line terminals if miswired. This applies both during its initial installation and after reinstallation following a correctly wired installation. If the device is provided with special instructions for removal and reinstallation, the instructions shall be followed during testing.

 

Leviton Responds with New Self-Test Models

In response to the revised standard, GFCI manufacturers must stop producing their current GFCIs and only manufacture the new self-test models as of the end of June. What this means is that you will notice a gradual transition in the market to self-test models by all manufacturers of GFCIs after that date. It is important to note that you can continue to sell and install any GFCI products manufactured prior to the effective date of the revised standard with no restrictions on phase out.

Click here to read the Self-Test GFCI Flyer from Leviton outlining which products are affected along with information on the new self-test products.

 

 

Click Here to Post a Comment Click Here to View Comments Click Here to Unsubscribe
 
Image
 
Visit: Exam Preparation | Continuing Education | Code Products | Newsletters | and more
Copyright© Mike Holt Enterprises of Leesburg, Inc. All Rights Reserved This article is protected by United States copyright laws and may not be published without prior written permission.
Mike Holt Enterprises of Leesburg, Inc. 3604 Parkway Blvd. Suite 3 Leesburg, FL 34748
"... as for me and my house, we will serve the Lord" [Joshua 24:15]
Comments
  • Seems that the new requirement will eventually phase out GFCI receptacles in new construction if the DUAL FUNCTION branch circuit disconnect is acceptable in dwellings. Consideration of using DUAL FUNCTION technology would at least eliminate multiple GFCI receptacle usage and testing potential flaws if the source GFCI protection is more stable.

    Ben Jacks  August 27 2015, 4:30 am EDT

Reply to this comment
* Your Name:
   Your name will appear under your comments.

* Your Email:
   Your email address is not displayed.
* Comments:

Email Notification Options:
Notify me when a reply is posted to this comment
Notify me whenever a comment is posted to this newsletter