This article was posted 11/05/2010 and is most likely outdated.

Code Forum Recap - October 2010
 

 


Subject - Code Forum Recap - October 2010

November 5, 2010
This newsletter was sent to 16466 newsletter subscribers
Ask a Question |  Continuing Education |  Quizzes |  Free Stuff |  Instructors |  Products | Seminars | Subscribe | Unsubscribe
[ image1 Post Comments | View Comments | Notify Me When Comments Are Added ]  

Mike Holt's Code Forum - October 2010
Top 30 New Topics

Another great resource from Mike Holt Enterprises! The following is a list of the top 30 topics discussed on our code forum in the past month. Simply click on any topic that interests you to read or join in the discussion. If you’re not already registered as a code forum member,click here to sign up now!

 

Click here to post a comment

[ Post Your Comments | View Comments | Notify Me When Comments Are Added ]
[ View More Newsletters ]

Bookmark and Share


Copyright © Mike Holt Enterprises, Inc. All rights reserved.
This article is protected by United States copyright and other intellectual property laws and may not be
displayed or published on the internet without the prior written permission of Mike Holt Enterprises, Inc.

http://www.MikeHolt.com     1-888-NEC-CODE (1-888-632-2633)

 
 
Comments

  • I installed a 30amp circuit for an arc welder that can draw a continous 19.25 amps. The problem is that the welder is wired(from the factory) for 120v with a standard 120v 3 prong plug. Everywhere and everyone I asked never heard of a 120v receptacle rated for 30 Amps. Also since the receptacle is outside the basement, do I need a GFCI receptacle which does not seem to come in 30amp either. I am lost on this one. Thanks for any help.

    Vic 7army elect insp
Reply to this comment
* Your Name:
   Your name will appear under your comments.

* Your Email:
   Your email address is not displayed.
* Comments:

This newsletter is closed to new comments.

Email Notification Options:
Notify me when a reply is posted to this comment
Notify me whenever a comment is posted to this newsletter