This article was posted before 01/01/2011 and is most likely outdated.

Elevated Voltage -
Dangers of Ungrounded Systems (2-21-2K)

Grounding & Bonding Articles Menu  

I have heard that one of the dangers of an ungrounded system is that the phase-to-ground voltage could elevate due to a ground fault. Example: A phase-to-ground voltage for a 480 volt ungrounded system could exceed 600 volts. Where can I get more information on this subject?

From: Neeser, Dan

IEEE Std. 242-1986 (Buff Book) addresses this issue. Below is text from reference standard:

7.2.5 Ungrounded Systems (p. 278, 279)

"If this ground fault is intermittent or allowed to continue, the system could be subjected to possible severe overvoltage to ground, which can be as high as six or eight times phase voltage. This can puncture insulation and result in additional ground faults. These overvoltage are caused by repetitive charging of the system capacitance, or by resonance between the system capacitance and the inductances of equipment in the system."

"Ungrounded systems offer no advantage over high-resistance grounded systems in terms of continuity of service, and have the disadvantages of transient overvoltage, locating the first ground fault and burndowns from a second ground fault."

From: Welshons, Kenny KK SNORC

From the IEEE Green Book 142-1972:

1.2.14 Restriking Ground Faults. Field experience and theoretical studies have shown that arcing, restriking, or vibrating ground faults on ungrounded systems can, under certain conditions, produce surge voltages as high as six times normal.

The conditions necessary for producing overvoltage require that the dielectric strength of the arc path build up at a higher rate after each extinction of the arc than it did after the preceding extinction. This phenomenon is unlikely to take place in open air between stationary contacts because such an arc path is not likely to develop sufficient dielectric recovery strength. It may occur in confined areas where the pressure may increase after each conduction period.

Neutral grounding is effective in reducing transient voltage buildup from such intermittent ground faults by reducing neutral displacement from ground potential and reducing destructive effectiveness of any high-frequency voltage oscillations following each arc initiation or restrike.

From: SimmElectServ@cs.com

Look at Pages 32 and 33 of the seventh edition of the IAEI Soares Book on Grounding I edited. I cover the effects of arcing or sputtering faults on a 480 volt ungrounded system. Here, the actual voltage on the system can reach several times the normal 480 volts. This is due to transient overvoltage. These high voltages can wipe out motor windings.

As I recall, EC&M ran a series of excellent articles on the subject of transient overvoltage on electrical systems a few years ago. The articles may be available on their Web site.